Honeycomb activated carbon
1、 the product features
Honeycomb activated carbon has a relatively large area, pore structure, high adsorption capacity, high surface activated carbon products, widely used in air pollution control.Choose honeycomb activated carbon adsorption method, the waste gas, contact with large porosity on the surface of the activated carbon adsorption decomposition, the pollutants in the exhaust gas is thus purifying effect.
With honeycomb activated carbon can remove contaminants that have different level: nitric oxide, carbon tetrachloride, chlorine, benzene, formaldehyde, acetone, ethanol, ethyl ether, methanol, acetic acid, ethyl ester, styrene, phosgene, fetor, etc.
After treatment with chemical reagents dipping modified honeycomb activated carbon can remove: acid mist, alkali fog, amine, mercaptan, sulfur dichloride, hydrogen sulfide, ammonia, mercury, a chlorinated carbon, dioxins, and so on.
2、 the instructions
Control the air pollution it is best to use honeycomb activated carbon, two adsorber in parallel form, can be used to handle intermittent exhaust, there can be used for continuous exhaust, including one for adsorption, another for stripping adsorber regeneration, the stripping of catalytic combustion pollutants after emptying.
Using honeycomb activated carbon high temperature to avoid as far as possible, because the high temperature will reduce the adsorption quantity, adsorption effect will be because of the temperature rise and fall.To avoid high dust content in the gas at the same time, because the tar dust may clog pores, activated carbon increase wind resistance, reduce the adsorption effect, in this case to installation of dust filtering device in front of the honeycomb activated carbon, can bring high efficiency and service life.
3、technical parameters
The main ingredients |
Activated carbon |
The normal compressive strength |
Greater than 0.8 MPa |
Commonly used specifications |
100*100*100mm |
The use of temperature |
Less than 400 degrees Celsius |
Hole density |
Holes per square inch, 150 holes per square inch |
Air tower wind speed |
0.8 m /seconds |
Specific surface area |
More than 700 square/g |
appearance |
Product surface smooth, no cracks |
Note: other specifications according to user requirements production.